Tag Archives: Eagle

PCB design: Eagle vs KiCad – the verdict

[Eagle vs KiCad part 11] Well here we are, the end of the road. Somehow I always knew this series would go to 11. I have, finally, made a decision which EDA – Eagle or KiCad – I’m going to use. It wasn’t an easy choice. Ground rules Let’s get a few things out of the way first, so you know… Read more »

PCB design: laying out the board with Eagle

[Eagle vs KiCad part 10] This is going to be a fairly short post because most of what I have to say can be summed up with: Eagle’s board layout program works very well and I had very few problems. It also offered very few features I wanted that KiCad didn’t. To create a board that will sync with your schematic… Read more »

PCB design: Eagle vs KiCad – a different direction

[Eagle vs KiCad part 8] So, as I mentioned in the previous post, I’ve decided to change direction slightly. Rather than continuing with the HexMonitor project to a completed and fabbed board, I’m going with a slightly simpler project. The reasons are two-fold: first, the HexMonitor board is sufficiently complex that I figured it had no chance of working, this being… Read more »

PCB design: connecting with Eagle

[Eagle vs KiCad part 4] In the last post in my Eagle vs KiCad series I’d got as far as using Eagle to place all the components for the HexMonitor project in a schematic. Now it’s time to join them together. Even before I begin, something tells me that perhaps this is too ambitious a project for my very first PCB…. Read more »

PCB design: modifying a part with Eagle

[Eagle vs KiCad part 3] In the last post, I’d got as far as putting all the parts for my HexMonitor project into the schematic, albeit without actually connecting them. There was a good reason for that: while I (somewhat surprisingly) found the connector part I needed in Eagle’s default libraries, it wasn’t labelled the way I wanted. This was… Read more »

PCB design: first steps with Eagle

[Eagle vs KiCad part 2] Okay, so it’s time to start on the road of deciding whether I want to design PCBs in Eagle or KiCad. I’ve already talked about this a little, but here’s where I’m at. My natural inclination is towards KiCad. It’s open and it has none of the restrictions of the free version of Eagle (and… Read more »

Eagle vs KiCad: first thoughts

      No Comments on Eagle vs KiCad: first thoughts

[Eagle vs KiCad part 1] There’s a tough decision awaiting anyone who, like me, is about to get into designing their own printed circuit boards (PCBs) – what software to use. An Electronic Design Automation (EDA) package is pretty much essential for any serious PCB work, and quite a lot of non-serious work too (which is where I come in)…. Read more »